A printed Christmas ornament is one of the highest-sentiment, lowest-cost projects in the entire FDM hobby. A few grams of filament and twenty minutes of print time produces something that, if it includes a name or a year, often ends up as a permanent fixture on the tree for years. This guide covers the design approaches that make ornaments look intentional rather than like a generic shape with a hole drilled in it, plus the settings that matter specifically for small decorative pieces.
Designing the Hanging Loop Correctly</h2
The single most common ornament design failure is a hanging loop that's too thin and snaps the first time it's hung. Design the loop as part of the main body, not a thin add-on detail: minimum 2.5-3mm thickness through the loop cross-section, and a hole diameter of 2-3mm to fit standard ornament hooks. Print the loop in the same orientation as the rest of the piece so layer lines run through its strongest axis rather than perpendicular to the hanging load. Vase Mode for Smooth Bulb and Geometric Ornaments</h2
Round bulb ornaments and faceted geometric ornaments (icosahedrons, dodecahedrons) are ideal vase mode candidates, covered in detail in our earlier vase mode guide. The continuous spiral wall eliminates the seam line that would otherwise run visibly down a smooth round ornament, and it prints fast since there’s no infill. A 70mm ornament in vase mode prints in 30-45 minutes depending on layer height. Flat Ornaments for Personalization</h2
Flat, single-sided ornaments (snowflakes, stars, simple silhouettes with a name or year embossed) are the easiest entry point for personalization and the fastest to batch print. Design text at minimum 1.5mm stroke width and 0.6mm emboss height for legibility at ornament viewing distance. A full plate of 8-10 flat ornaments with different names prints in under an hour, making these the practical choice for gifting an entire family or classroom.
Round bulb ornaments and faceted geometric ornaments (icosahedrons, dodecahedrons) are ideal vase mode candidates, covered in detail in our earlier vase mode guide. The continuous spiral wall eliminates the seam line that would otherwise run visibly down a smooth round ornament, and it prints fast since there’s no infill. A 70mm ornament in vase mode prints in 30-45 minutes depending on layer height.
Flat Ornaments for Personalization</h2
Flat, single-sided ornaments (snowflakes, stars, simple silhouettes with a name or year embossed) are the easiest entry point for personalization and the fastest to batch print. Design text at minimum 1.5mm stroke width and 0.6mm emboss height for legibility at ornament viewing distance. A full plate of 8-10 flat ornaments with different names prints in under an hour, making these the practical choice for gifting an entire family or classroom.
Settings for Ornaments</h2
| Ornament Type | Layer Height | Infill / Walls | Notes |
|---|---|---|---|
| Vase mode round/geometric | 0.12-0.16mm | N/A (vase mode) | Fine layer height matters more on curved surfaces |
| Flat personalized | 0.16-0.2mm | 3 walls, 15% | Standard solid small-part settings |
| Detailed figural (Santa, snowman, etc.) | 0.12mm | 100% (small solid piece) | Fine detail benefits from solid infill at this scale |